Hospitals & Healthcare
Hygienic and sterilization heat exchangers for medical facility HVAC, hot water and process utilities.
Use cases
- Central HVAC heat exchange
- Sterilizer hot water and cooling
- Domestic hot water for wards
- Clean-utility temperature control
Recommended products
- Gasketed Plate Heat ExchangerA gasketed plate heat exchanger uses a removable corrugated plate pack with elastomer gaskets for liquid-to-liquid heating, cooling and heat recovery..
- Brazed Plate Heat ExchangerA brazed plate heat exchanger joins corrugated plates by vacuum brazing into a sealed pack.
- Shell and Tube Heat ExchangerA shell-and-tube heat exchanger transfers heat between a fluid inside tubes and a second fluid within the shell.
- Food Grade Heat ExchangerA food-grade heat exchanger uses a sanitary removable plate or sanitary shell-and-tube construction for dairy, beverages, juice, sauces, syrups, CIP heating and pasteurization.
- Heat Exchanger Gaskets, Plates & Spare PartsReplacement heat exchanger plates and gaskets restore the heat-transfer surfaces and seals of an existing plate pack.
Typical operating conditions
- Process media: hot water, chilled water, steam condensate, sterilizer feed
- Temperature range: 2–140 °C
- Design pressure: typically 10–16 barg
- 24/7 duty with strict hygienic and reliability requirements
Common engineering challenges
- Legionella-safe DHW temperature control
- Reliable pressure separation between circuits
- Cleanability and material traceability
- Redundancy and easy maintenance without disrupting service
Recommended materials & construction
- AISI 316L plates with sanitary or hygienic finish on request
- Double-wall construction for critical clean-utility interfaces
- EPDM potable-water / WRAS-compliant gaskets
- Corrosion-resistant frame construction for humid plant rooms
Typical delivery scope
- Duty sizing per hospital HVAC and DHW loads
- Redundant N+1 configuration on request
- Material 3.1 certificates for wetted parts
- Commissioning, O&M and spare-part documentation
Ranges shown are indicative for this industry. Actual design is confirmed per project against your duty sheet.
Get in touch
Need a Heat Exchanger for Your Project?
Send your working conditions, drawing or datasheet. Blair will review your request and help confirm the next step.